Innovations in ventilators and its prototype modeling

Inspiration

What it does

How we built it

Challenges we ran into

Accomplishments that we're proud of

What we learned

What's next for Innovations in ventilators and its prototype modeling

Patients are put on ventilators when they can't inhale alone. This might be for any of the accompanying reasons: To ensure that the patient is getting enough oxygen and is disposing of carbon dioxide. After medical procedure, the patient may require a ventilator to inhale since they may have been given a few meds that reason them lethargic and their breathing has not come back to typical. A patient has a sickness or damage and can't inhale ordinarily. The main contribution of our project is to design a portable ventilator model which can be used for measuring the respiration status of humans. A prototype is developed which is a cost effective one by placing the potentiometer and needle valve in place of flow analyser. At initial stage our ventilator were be working with amount of 1 bar in compressed air through the regulator, then moving to the solenoid valve for on & off condition. From solenoid end two ways are developed, one end is connecting in needle valve and potentiometer the other end is exhalation valve. After adjusting the flow of air through needle valve and potentiometer the tube was developed from 6mm to 8mm for the connection purpose of test lung bag. It were be used to show the inhalation and exhalation of patient. Finally, the total prototype was able to illustrate the major four parameter of ventilator.

Built With

• hardware